Adhesives for PVC pipe
Useful information
Solvent application form and PVC adhesive
-
1
Cut the pipe at right angles, bevel the edges, and measure and mark the pipe to be bonded.
-
2
Clean the bonding surfaces with cleaning solvent Collak DL.
-
3
Applying a uniform layer of adhesive Collak for PVC, in the two parts to be joined, in the inside and the other on the outside.
-
4
Then without turning effect binding or movement during the time stipulated in the boat of used product.
-
5
Remove the excess adhesive before drying.
|
|
|
|
|
Approximate consumption of PVC adhesive and cleaning solvent.
Amount needed in liters for 100 joints.
ØDN | PVC-25 | DL |
16 | 0.30 | 0.14 |
10 | 0.40 | 0.19 |
25 | 0.50 | 0.28 |
32 | 0.70 | 0.40 |
40 | 1.00 | 0.60 |
50 | 1.70 | 0.89 |
63 | 2.60 | 1.10 |
75 | 3.60 | 1.65 |
90 | 4.60 | 1.60 |
ØDN | PVC-25 | DL |
110 | 6.50 | 1.19 |
125 | 8.00 | 2.10 |
140 | 9.90 | 2.50 |
160 | 12.60 | 2.70 |
180 | 15.50 | 3.25 |
200 | 17.80 | 3.80 |
250 | 29.40 | 6.50 |
315 | 41.30 | 80 |
400 | 65.00 | 10.15 |
Tips and recommendations
– Remember to check that the joint surfaces are not deformed or defects.
– Note That the Temperature Affects the welding process.
– The best temperature range for the glueing is 10 ° C to 30 ° C. Extreme cold can be harmful.